The Http Redirect Screen - ZyXEL Communications ZyWALL USG 300 User Manual

• a application patrol rule to allow HTTP traffic between ge4 and ge2.
• a policy route to forward HTTP traffic from proxy server A to the Internet.
Finding Out More
See Section 5.4.20 on page 94

17.2 The HTTP Redirect Screen

To configure redirection of a HTTP request to a proxy server, click Network >
HTTP Redirect. This screen displays the summary of the HTTP redirect rules.
Note: You can configure up to one HTTP redirect rule for each (incoming) interface.
Figure 208 Network > HTTP Redirect
The following table describes the labels in this screen.
Table 95 Network > HTTP Redirect
LABEL
Name
Interface
Proxy Server
Port
Add icon
Apply
Reset
ZyWALL USG 300 User's Guide
for related information on these screens.
DESCRIPTION
This is the descriptive name of a rule.
This is the interface on which the request must be received.
This is the IP address of the proxy server.
This is the service port number used by the proxy server.
Click the Add icon in the heading row to add a new entry.
The Active icon displays whether the rule is enabled or not. Click the
Active icon to activate or deactivate the rule. Make sure you click Apply
to save and apply the change.
Click the Edit icon to go to the screen where you can edit the rule on the
ZyWALL.
Click the Remove icon to delete an existing rule from the ZyWALL. A
window displays asking you to confirm that you want to delete the rule.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Chapter 17 HTTP Redirect
315