Configuring The Policy Route For L2Tp Example - ZyXEL Communications ZyWALL USG 300 User Manual

28.5 Configuring the Policy Route for L2TP
Example
Click Routing > Add to open the following screen.
1
Figure 300 Routing > Add: L2TP VPN Example
Configure the following.
2
• Enable the policy route.
• Set the policy route's Source Address to the address object that you want to
allow the remote users to access (LAN_SUBNET in this example).
• Set the Destination Address to the IP address pool that the ZyWALL assigns
to the remote users (L2TP_POOL in this example).
• Set the next hop to be the Default_L2TP_VPN_Connection VPN tunnel.
• Click OK.
ZyWALL USG 300 User's Guide
Chapter 28 L2TP VPN Example
441