Telnet; Configuring Telnet - ZyXEL Communications ZyWALL USG 300 User Manual

Enter "ssh –1 192.168.1.1". This command forces your computer to connect to
2
the ZyWALL using SSH version 1. If this is the first time you are connecting to the
ZyWALL using SSH, a message displays prompting you to save the host
information of the ZyWALL. Type "yes" and press [ENTER].
Then enter the password to log in to the ZyWALL.
Figure 522 SSH Example 2: Log in
$ ssh –1 192.168.1.1
The authenticity of host '192.168.1.1 (192.168.1.1)' can't be established.
RSA1 key fingerprint is 21:6c:07:25:7e:f4:75:80:ec:af:bd:d4:3d:80:53:d1.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added '192.168.1.1' (RSA1) to the list of known hosts.
Administrator@192.168.1.1's password:
The CLI screen displays next.
3

46.8 Telnet

You can use Telnet to access the ZyWALL's command line interface. Specify which
zones allow Telnet access and from which IP address the access can come.

46.8.1 Configuring Telnet

Click System > TELNET to configure your ZyWALL for remote Telnet access. Use
this screen to specify from which zones Telnet can be used to manage the
ZyWALL. You can also specify from which IP addresses the access can come.
Figure 523 System > Telnet
ZyWALL USG 300 User's Guide
Chapter 46 System
761