ZyXEL Communications ZyWALL USG 300 User Manual page 802

Chapter 49 Reports
• Most-used protocols or service ports and the amount of traffic on each one
• LAN IP with heaviest traffic and how much traffic has been sent to and from
each one
You use the Traffic Statistics screen to tell the ZyWALL when to start and when
to stop collecting information for these reports. You cannot schedule data
collection; you have to start and stop it manually in the Traffic Statistics screen.
Figure 547 Maintenance > Report > Traffic Statistics
There is a limit on the number of records shown in the report. Please see
259 on page 804
this screen.
Table 258 Maintenance > Report > Traffic Statistics
LABEL
Data Collection
Collect
Statistics
Apply
Reset
Statistics
Interface
Traffic Type
Refresh
802
for more information. The following table describes the labels in
DESCRIPTION
Select this to have the ZyWALL collect data for the report. If the ZyWALL
has already been collecting data, the collection period displays to the
right. The progress is not tracked here real-time, but you can click the
Refresh button to update it.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Select the interface from which to collect information. You can collect
information from Ethernet, VLAN, bridge, PPPoE/PPTP, and auxiliary
interfaces.
Select the type of report to display. Choices are:
Host IP Address/User - displays the IP addresses or users with the
most traffic and how much traffic has been sent to and from each one.
Service/Port - displays the most-used protocols or service ports and
the amount of traffic for each one.
Web Site Hits - displays the most-visited Web sites and how many
times each one has been visited.
Each type of report has different information in the report (below).
Click this button to update the report display.
Table
ZyWALL USG 300 User's Guide