ZyXEL Communications ZyWALL USG 300 User Manual page 781

Table 250 Maintenance > File Manager > Configuration File (continued)
LABEL
Delete
Run
#
File Name
Size
Last
Modified
Upload
Configurati
on File
File Path
ZyWALL USG 300 User's Guide
DESCRIPTION
Click a configuration file's row to select it and click Delete to remove the
configuration file from the ZyWALL. You can only delete manually saved
configuration files. You cannot delete the system-default.conf, startup-
config.conf and lastgood.conf files.
A pop-up window asks you to confirm that you want to delete the
configuration file. Click OK to delete the configuration file or click Cancel to
close the screen without deleting the configuration file.
Use this button to have the ZyWALL use a specific configuration file.
Click a configuration file's row to select it and click Run to have the ZyWALL
use that configuration file. The ZyWALL does not have to restart in order to
use a different configuration file, although you will need to wait for a few
minutes while the system reconfigures.
This column displays the number for each configuration file entry. The total
number of configuration files that you can save depends on the sizes of the
configuration files and the available flash storage space.
This column displays the label that identifies a configuration file.
You cannot delete the following configuration files or change their file
names.
The system-default.conf file contains the ZyWALL's default settings.
Select this file and click Apply to reset all of the ZyWALL settings to the
factory defaults. This configuration file is included when you upload a
firmware package.
The startup-config.conf file is the configuration file that the ZyWALL is
currently using. If you make and save changes during your management
session, the changes are applied to this configuration file. The ZyWALL
applies configuration changes made in the Web Configurator to the
configuration file when you click Apply or OK. It applies configuration
changes made via commands when you use the write command.
The lastgood.conf is the most recently used (valid) configuration file that
was saved when the device last restarted. If you upload and apply a
configuration file with an error, you can apply lastgood.conf to return to a
valid configuration.
This column displays the size (in KB) of a configuration file.
This column displays the date and time that the individual configuration files
were last changed or saved.
The bottom part of the screen allows you to upload a new or previously
saved configuration file from your computer to your ZyWALL
You cannot upload a configuration file named system-default.conf or
lastgood.conf.
If you upload startup-config.conf, it will replace the current configuration
and immediately apply the new settings.
Type in the location of the file you want to upload in this field or click
Browse ... to find it.
Chapter 47 File Manager
781