Crosstrax Awd Control Manifold - Toro Groundsmaster 360 Service Manual

TM
CrossTrax AWD Control Manifold (4WD Machines)
RIGHT
FRONT
1. Cap screw (2 used)
2. Flange nut (2 used)
o
3. 90 hydraulic fitting
4. Mount (2 used)
5. Washer (4 used)
Removal (Fig. 119)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
WARNING
Before disconnecting or performing any work on
the hydraulic system, all pressure in the system
must be relieved. See Relieving Hydraulic System
Pressure in the General Information section.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Hydraulic System
12
Figure 119
6. O- -ring
7. O- -ring
8. Washer (2 used)
o
9. 45 hydraulic fitting (2 used)
10. Mount plate
Page 4 - - 100
14
13
5
4
10
5
1
11. Straight fitting
12. Carriage screw (2 used)
13. AWD control manifold
14. Steering control manifold
3. Raise and support operator seat. Locate AWD con-
trol manifold.
4. Thoroughly clean hydraulic hose ends prior to dis-
connecting hoses from the AWD control manifold. Label
all hydraulic connections for assembly purposes (Fig.
120).
5. Disconnect hydraulic hoses from control manifold.
The hoses at control manifold ports LR and RR need to
be disconnected at hydraulic tubes before removal from
manifold (Fig. 120).
6. Install clean caps or plugs on disconnected hoses
and fittings to prevent contamination.
7. Support manifold to prevent it from falling.
9
6
7
11
6
3 7
6
8
2
Groundsmaster 360