Transmission Assembly - Toro Groundsmaster 360 Service Manual

Transmission Assembly (Fig. 63)
IMPORTANT: When assembling the transmission,
lubricate all transmission components with clean
hydraulic oil.
1. Make sure that all transmission components are
thoroughly clean before assembling the transmission.
2. Apply clean hydraulic oil to washers and swash plate
surfaces. Install washer onto each swash plate and
carefully install swash plates into transmission pump
housing.
3. Press oil seal into both side covers and secure with
retaining ring. Lubricate new O--rings and install onto
side covers.
4. Carefully slide side covers over trunnion shafts tak-
ing care to not damage seals. Secure both side covers
to transmission pump housing with three (3) socket
head screws. Torque screws from 78 to 95 in- -lb (8.8 to
10.8 N- -m).
5. Lubricate new O--rings and install onto two (2) plugs.
Install plugs into transmission pump housing. Torque
plugs from 17 to 19 ft- -lb (22 to 27 N- -m).
Hydraulic System
1
3
1. Swash plate (2 used)
2. Washer
4
5
1. Side cover
2. O- -ring
3. Pump housing
2
1. Socket head plug
2. Hex plug
Page 4 - - 90
2
Figure 91
3. Pump housing
2
3
Figure 92
4. Retaining ring
5. Oil seal
1
Figure 93
3. Pump housing
Groundsmaster 360
1
3