Engine - Toro Groundsmaster 360 Service Manual

Engine

RIGHT
FRONT
Antiseize
Lubricant
26
23
25
3
17
29
21
20
24
19
1. Engine
2. Thermoswitch
3. Cable support
4. Fan
5. Fan pulley
6. Flange head screw (4 used)
7. Fan spacer
8. Hex nut
9. Lock washer
10. Flat washer
11. Engine mount (2 used) (yellow top)
Engine Removal (Fig. 9)
NOTE: When removing the engine using the following
procedure, the flywheel housing and transmission will
remain in the machine.
1. Park machine on a level surface, lower cutting unit,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove hood from machine (see Hood Removal in
the Service and Repairs section of Chapter 6 -- Chas-
sis).
Kubota Diesel Engine
70 to 86 in- -lb
8
(7.9 to 9.7 N- -m)
1
27
30
31
22
28
12. Motor mount plate (2 used)
13. Cap screw (2 used)
14. Flange nut (2 used)
15. Snubbing washer (2 used)
16. Cap screw (4 used per plate)
17. Lock washer (10 used)
18. Flange screw (4 used)
19. Flange nut (6 used)
20. Engine mount (2 used) (red top)
21. Flange head screw (4 used)
22. Flange nut (4 used)
32
9 10
2
33
18
Figure 9
3. Raise and support operator seat.
4. Disconnect both battery cables from the battery. Dis-
connect negative cable first and then positive cable (see
Battery Service in the Service and Repairs section of
Chapter 5 -- Electrical System).
5. Remove air cleaner from the engine (see Air Cleaner
Assembly Removal in this section).
6. Remove muffler from the engine (see Muffler Re-
moval in this section).
Page 3 - - 14
4
6
7
5
34 to 42 ft- -lb
(47 to 56 N- -m)
14
12
17
16
11
15
13
Loctite #271
19 ft- -lb
(26 N- -m)
19
23. Cap screw (2 used)
24. Hardened washer (2 used)
25. Flat washer (2 used)
26. Flywheel housing
27. Dowel pin (2 used)
28. Flange head screw (6 used)
29. Socket head screw (2 used)
30. Flywheel coupling
31. Cap screw (6 used)
32. V- -belt
Groundsmaster 360