Heater/Evaporator Assembly - Toro Groundsmaster 360 Service Manual

Heater/Evaporator Assembly

10
14
13
1. Heater/evaporator assembly
2. Top cover
3. Flange head screw (2 used)
4. Drier- -receiver mount
5. Bottom cover
6. Hose clamp (2 used)
7. Panel nut (8 used)
8. Panel nut (4 used)
Removal (Fig. 7)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove fasteners that secure roof in place. Raise
and support roof to allow access to heater/evaporator
assembly (see Roof Assembly Removal in this section).
Operator Cab
1
21
22
12
9. Drier- -receiver assembly
10. Screw (8 used)
11. Screw (4 used)
12. Seal
13. Seal
14. Air duct hose
15. Binary switch
16. Blower fan assembly
2
5
Figure 7
3. Disconnect wire harness connectors from fan motor
and binary switch on drier--receiver.
4. Read the General Precautions for Removing and
Installing Air Conditioning System Components at the
beginning of the Service and Repairs section of this
chapter.
Page 8 - - 10
18
17
19
16
23
20
3
4
8
11
7
17. Screw (2 used)
18. Resistor
19. Screw (12 used)
20. Expansion valve
21. Screw (2 used)
22. Freeze switch
23. Clamp
Groundsmaster 360
15
9
6