Crosstrax™ Awd Control Manifold Assembly - Toro Reelmaster 5410 Series Service Manual

CrossTrax™ AWD Control Manifold Assembly
g186174
1. Hydraulic hose (4 each)
2. Straight fitting (7 each)
3. AWD control manifold
4. Hydraulic tube
5. Hydraulic tube
Removing the CrossTrax AWD Control Manifold Assembly
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
6. Hydraulic tube
7. O-ring (7 each)
8. O-ring (7 each)
9. Dust cap (2 each)
10. Diagnostic fitting (2 each)
1. Park the machine on a level surface, lower the cutting units, shut off the
engine, set the parking brake, and remove the key from the key switch.
Before opening the hydraulic system, operate all the hydraulic
controls to release system pressure and avoid injury from the
pressurized hydraulic fluid; refer to
Hydraulic System (page
2. Read the General Precautions for Removing and Installing the Hydraulic
System Components (page
3. Locate the CrossTrax AWD control manifold that is attached to the bracket
at rear of the frame.
4. For assembly purposes, label all the hydraulic connections. Clean the
hydraulic connections before loosening the hydraulic lines.
Figure 161
11.
12.
13.
14.
15.
CAUTION
Releasing Pressure from the
6–8).
6–145).
Page 6–185
O-ring (2 each)
Frame bracket
Bolt (3 each)
Lock washer (3 each)
Spacer (3 each)
Hydraulic System: Service and Repairs