Toro Groundsmaster 360 Service Manual page 97

Hydraulic Tank Removal (Fig. 45)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Raise and support operator seat.
3. Drain hydraulic oil from hydraulic tank into a suitable
container.
4. Remove hydraulic tank cover from machine (see
Control Console Disassembly in the Service and Re-
pairs section of Chapter 6 -- Chassis).
5. Thoroughly clean hydraulic hose ends and fittings on
hydraulic tank to prevent hydraulic system contamina-
tion.
6. Label all hydraulic hoses and fittings for assembly
purposes. Remove hydraulic hoses from fittings on hy-
draulic tank (Fig. 46). Drain hoses into a suitable con-
tainer.
7. Put clean plugs in disconnected hydraulic hoses and
fittings to prevent system contamination.
8. Remove four (4) flange head screws that secure hy-
draulic tank to frame.
9. Remove hydraulic tank from machine.
10.As needed, remove fittings from hydraulic tank using
Figure 45 as a guide. Discard and replace any removed
O--rings.
Hydraulic Tank Inspection (Fig. 45)
1. Clean hydraulic tank and suction strainer with sol-
vent.
2. Inspect hydraulic tank for leaks, cracks or other dam-
age.
Groundsmaster 360
Hydraulic Tank Installation (Fig. 45)
1. Attach removed suction strainer and fittings with
new, lubricated O--rings to hydraulic tank using Figure
45 as a guide (see Hydraulic Fitting Installation in the
General Information section of this chapter). Torque fit-
tings to values identified in Figure 45.
2. Position hydraulic tank to machine. Secure tank to
frame with four (4) flange head screws.
3. Remove plugs that were installed in hydraulic hoses
and fittings during the removal procedure.
4. Using labels placed during removal, attach hydraulic
hoses to fittings on hydraulic tank (Fig. 46) (see Hydrau-
lic Hose and Tube Installation in the General Information
section of this chapter).
5. Fill hydraulic tank with new hydraulic fluid.
6. Install hydraulic tank cover to machine (see Control
Console Assembly in the Service and Repairs section of
Chapter 6 -- Chassis).
7. Lower and secure operator seat.
8. Operate machine. Check hydraulic oil level and ad-
just if necessary. Check hydraulic components for leaks.
Tighten any loose connections.
1
1. Hydraulic tank
2. Transmission
Page 4 - - 63
3
Figure 46
3. Gear pump
Hydraulic System
2