Fuses (2Wd Machines) - Toro Groundsmaster 360 Service Manual

Fuses (2WD Machines)

The fuse block is attached to the seat support under the
operator seat.
Fuse Identification and Function
Use Figure 27 to identify each individual fuse and its cor-
rect amperage. Fuses for the Groundsmaster 360 with
2WD have the following function:
Upper Fuse 1 (10 Amp): Protects power supply for
ignition switch circuits.
Upper Fuse 2 (15 Amp): Protects power supply for
power point and optional light kit.
Upper Fuse 3 (10 Amp): Protects main power sup-
ply including SCM outputs.
Upper Fuse 4 (10 Amp): Protects optional differen-
tial lock power supply.
Lower Fuse 1 (15 Amp): Protects power supply for
cutting deck lift circuit.
Lower Fuse 2 (10 Amp): Protects power supply for
SCM logic.
Lower Fuse 3 (2 Amp): Protects power supply for
optional air ride seat.
Lower Fuse 4 (10 Amp): Protects power supply for
optional light kit.
Fuse Testing
Make sure that ignition switch is OFF and key is re-
moved from switch. Remove fuses from the fuse block
for testing. Fuse should have continuity between fuse
terminals.
Electrical System
UPPER
LOWER
Page 5 - - 28
4 3 2 1
4 3 2 1
Figure 27
Groundsmaster 360