Toro Groundsmaster 360 Service Manual page 243

Removal (Fig. 11)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Chock wheels to prevent machine from shifting.
3. Loosen wheel lug nuts.
CAUTION
Before raising the machine, review and follow
Jacking Instructions in Chapter 1 - - Safety.
4. Using a jack, raise machine so wheel is off ground
(see Jacking Instructions in Chapter 1 -- Safety). Sup-
port machine with jack stands.
5. Remove lug nuts and then remove wheel from ma-
chine.
6. If front wheel was removed, locate and retrieve front
wheel spacer.
Groundsmaster 360
Installation (Fig. 11)
1. If front wheel was removed, position front wheel
spacer to wheel hub.
2. Install wheel and secure with five (5) lug nuts.
3. Lower machine to ground.
Failure to maintain proper wheel lug nut torque
could result in failure or loss of wheel and may re-
sult in personal injury.
4. Torque lug nuts evenly in a crossing pattern from 75
to 85 ft- -lb (102 to 115 N- -m).
5. Check and adjust tire pressures (see Specifications
in this chapter).
Page 6 - - 9
WARNING
Chassis