Toro Groundsmaster 360 Service Manual page 126

10.Install clutch assembly and gear onto PTO shaft:
A. Install key into PTO shaft slot making sure that
rounded ends of key align with rounded ends of shaft
slot.
B. Slide clutch assembly and gear onto PTO shaft
making sure to align slot in clutch with key in shaft.
Also, align rods in clutch with holes in B--plate.
C. Place spacer onto PTO shaft.
D. Press bearing onto PTO shaft so bearing is flush
with shaft shoulder.
11. Apply clean hydraulic oil to friction plate and place in
transmission pump housing. Make sure that tabs on fric-
tion plate are placed in housing grooves.
12.Install PTO shaft assembly into transmission pump
housing. Make sure that tabs on friction plates are
placed in housing grooves.
Hydraulic System
2
1. Bearing
2. PTO shaft
3. Spacer
2
1. Friction plate
3
2
1. PTO shaft assembly
2. Pump housing
Page 4 - - 92
5
6
4
Figure 97
4. Gear
5. Clutch assembly
6. Key
Figure 98
2. Pump housing
1
4
Figure 99
3. Friction plate tabs
4. Housing groove
Groundsmaster 360
1
3
1