Toro Groundsmaster 360 Service Manual page 109

4. On both sides of machine, remove cap screw and
flange nut that secures the pump control arm to the
speed control shaft (Fig. 60). Note that cap screw is
installed toward the right side of the machine. Locate
and retrieve lock washer from between control arm and
control shaft.
5. Unplug wire harness electrical connector from trans-
mission solenoid valve coil. Position wire harness away
from transmission.
6. Drain oil from hydraulic tank and transmission.
IMPORTANT: When repositioning seat channel to
allow transmission removal, make sure to not dam-
age the electrical harness or other parts.
7. Remove two (2) carriage screws and flange nuts that
secure seat channel to frame (Fig. 61). Separate chan-
nel from frame and carefully position channel away from
frame to allow easier transmission removal.
8. Thoroughly clean hydraulic hose ends and fittings on
transmission and gear pump to prevent hydraulic sys-
tem contamination.
9. Label all hydraulic hoses and fittings on transmission
and gear pump for assembly purposes. Remove hy-
draulic hoses from fittings on transmission and gear
pump. Allow hoses to drain into a suitable container.
10.Install clean plugs in hose and fitting openings to pre-
vent system contamination.
NOTE: Two (2) 8 mm eyebolts can be installed into
threaded bosses in top of transmission to allow use of
a lift or hoist to remove transmission.
CAUTION
Support transmission assembly when removing
it from the flywheel housing to prevent it from fal-
ling and causing personal injury. Transmission
weighs approximately 90 pounds (41 kg).
11. Remove seven (7) cap screws and lock washers that
secure the transmission to the flywheel housing. Note
location of the shorter cap screw for assembly pur-
poses.
IMPORTANT: Make sure to not damage the trans-
mission, flywheel housing, hydraulic lines, electri-
cal harness or other parts while removing
transmission.
Groundsmaster 360
FRONT
8
4
1. Speed control shaft
2. Retaining ring
3. Washer
4. Flange nut
5. Lock washer
RIGHT
FRONT
1. Seat channel
2. Carriage screw (2 used)
Page 4 - - 75
10
7
2
3
9
5
6
9
1
4
5
6
Figure 60
6. Cap screw
7. ASC control arm
8. Neutral sensor
9. Control arm
10. Transmission
3
1
2
4
Figure 61
3. Shoulder bolt (2 used)
4. Flange nut (2 used)
Hydraulic System
3
2