Steering Cylinder - Toro Groundsmaster 360 Service Manual

Hide thumbs Also See for Groundsmaster 360:
Table of Contents

Advertisement

Steering Cylinder

83 to 101 ft- -lb
(113 to 136 N- -m)
9
11
10
12
13
14
15
RIGHT
FRONT
57 to 75 ft- -lb
(78 to 101 N- -m)
1. Front axle assembly
2. Steering cylinder spacer
3. Hydraulic hose
4. O- -ring
5. Hydraulic fitting (2 used)
6. O- -ring
7. Hydraulic hose
Removal (Fig. 132)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. If front steering cylinder is to be removed from ma-
chine, remove front cover from front axle to allow access
to front steering cylinder (Fig. 133).
3. If rear steering cylinder is to be removed from ma-
chine, the storage compartment behind operator seat
needs to be removed to allow clearance for cylinder re-
moval. To remove storage compartment, see Storage
Compartment Removal in the Service and Repairs sec-
tion of Chapter 6 -- Chassis or, if machine is equipped
with operator cab, see Storage Compartment Removal
in the Service and Repairs section of Chapter 8 -- Opera-
tor Cab.
Hydraulic System
FRONT AXLE
8
7
6
5
4
3
2
1
16
14
80 to 90 ft- -lb
(109 to 122 N- -m)
8. Retaining ring
9. Grease fitting
10. Ball joint
11. Jam nut
12. Cylinder rod end
13. Steering cylinder
Page 4 - - 116
REAR AXLE
8
10
17
19
RIGHT
FRONT
Figure 132
4. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Before disconnecting or performing any work on
the hydraulic system, all pressure in the system
must be relieved. See Relieving Hydraulic System
Pressure in the General Information section of
this chapter
5. Label all hydraulic connections for assembly pur-
poses. Thoroughly clean hydraulic hose ends prior to
disconnecting hoses from the steering cylinder.
83 to 101 ft- -lb
9
(113 to 136 N- -m)
18
4
13
2
16
14
80 to 90 ft- -lb
(109 to 122 N- -m)
14. Cotter pin
15. Slotted hex nut
16. Slotted hex nut
17. Rear axle assembly
18. Hydraulic hose
19. Hydraulic hose
WARNING
Groundsmaster 360
5
6
11
12
14
15

Advertisement

Table of Contents
loading

Table of Contents