Fuses (4Wd Machines) - Toro Groundsmaster 360 Service Manual

Fuses (4WD Machines)

The fuse block is attached to the seat support under the
operator seat.
In addition to the fuses in the fuse blocks, a 2 amp in--line
fuse is included in the wire harness. This fuse protects
the TEC logic power circuit and resides in a fuse holder
near the battery (Fig. 29).
Fuse Identification and Function
Use Figure 28 to identify each individual fuse and its cor-
rect amperage. Fuses for the Groundsmaster 360 with
4WD have the following function:
Upper Fuse 1 (10 Amp): Protects power supply for
operator cab power relay circuit.
Upper Fuse 2 (7.5 Amp): Protects power supply for
TEC outputs 1 through 4 (start relay, fuel pump, fuel
solenoid hold coil, glow relay and diagnostic light).
Upper Fuse 3 (7.5 Amp): Protects power supply for
TEC outputs 5 through 8 (mow clutch coil, steering
selector switch indicator light, deck lift manifold S1
and S2 coils).
Upper Fuse 4 (7.5 Amp): Protects power supply for
TEC outputs 9 through 12 (steer mode selector valve
coil). TEC outputs 10, 11 and 12 are not used on the
Groundsmaster 360.
Lower Fuse 1 (10 Amp): Protects power supply for
main power supply.
Lower Fuse 2 (15 Amp): Protects power supply for
power point and optional light kit.
Lower Fuse 3 (10 Amp): Protects power supply for
optional air ride seat.
Lower Fuse 4 (10 Amp): Protects power supply for
optional light kit.
Fuse Testing
Make sure that ignition switch is OFF and key is re-
moved from switch. Remove fuses from the fuse block
for testing. Fuse should have continuity between fuse
terminals.
Groundsmaster 360
UPPER
LOWER
1. Battery
Page 5 - - 29
4 3 2 1
4 3 2 1
Figure 28
2
1
Figure 29
2. In- -line fuse
Electrical System