Toro Groundsmaster 360 Service Manual page 128

17.Place two (2) pins into transmission pump housing
holes. Position new gasket to housing.
18.Carefully place gear case housing onto pump hous-
ing making sure to align pins, pipe and shaft bearings.
19.Secure gear case housing to pump housing with fif-
teen (15) flange head screws. Tighten screws evenly in
a crossing pattern and then torque screws from 17 to 19
ft- -lb (22 to 27 N- -m).
20.Taking care to not damage input shaft oil seal, install
oil seal into gear case housing bore. Place spacer on oil
seal and secure with retaining ring.
21.Lubricate new O--rings and install O--rings onto three
(3) plugs. Install plugs into transmission assembly.
Torque hex plugs from 14 to 15 ft- -lb (18 to 21 N- -m) and
socket head plug from 17 to 19 ft- -lb (22 to 27 N- -m).
Hydraulic System
1
3
2
1. Gear case housing
2. Pump housing
2
1. Hex plug
Page 4 - - 94
Figure 102
3. Pin (2 used)
1
Figure 103
2. Socket head plug
Groundsmaster 360
1