Front Wheel Motors (4Wd Machines) - Toro Groundsmaster 360 Service Manual

Front Wheel Motors (4WD Machines)

RIGHT
FRONT
1. Front wheel motor (LH shown)
2. O- -ring
3. Wheel hub
4. Wheel spacer
5. Wheel stud (5 used per wheel)
6. Cap screw (4 used per motor)
Removal (Fig. 49)
WARNING
Before disconnecting or performing any work on
the hydraulic system, all pressure in the system
must be relieved. See Relieving Hydraulic System
Pressure in the General Information section.
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
Hydraulic System
1
Loctite #271
94 to 116 ft- -lb
(128 to 157 N- -m)
7. Square key
o
8. 45 fitting (2 used per motor)
9. Cap screw (2 used per bracket)
10. Lug nut (5 used per wheel)
11. Hydraulic tube
Page 4 - - 66
11
16
12
14
16
9
8
2
7
6
5
3
4
Figure 49
2. Loosen but do not remove lock nut (item 15) that se-
cures wheel hub to wheel motor. Also loosen wheel lug
nuts.
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 - - Safety.
3. Jack up machine enough to allow the removal of the
front wheel. Support machine with jack stands.
300 to 400 ft- -lb
(407 to 542 N- -m)
75 to 85 ft- -lb
(102 to 115 N- -m)
13
15
12. Bulkhead bracket
13. Front wheel assembly
14. Hydraulic tube
15. Lock nut
16. O- -ring
WARNING
Groundsmaster 360
10