Operator Cab) - Toro Groundsmaster 360 Service Manual

Operator Cab Fuses (4WD Machines with Operator Cab)
The operator cab fuse blocks are located in the cab
headliner (Fig. 30).
In addition to the cab fuses in the fuse blocks, a 50 amp
maxi--fuse is included in the operator cab wire harness.
This fuse protects the cab power circuits and resides in
a fuse holder attached to the air cleaner bracket near the
rear steering cylinder.
Fuse Identification and Function (Fig. 31)
Fuse F1- -1 (15 Amp): Protects the cab work light circuit.
Fuse F1- -2 (15 Amp): Protects the cab heater circuit.
Fuse F1- -3 (30 Amp): Protects the air conditioner cir-
cuit.
Fuse F2- -1 (15 Amp): Protects the windshield wiper/
washer circuit.
Fuse F2- -2 (15 Amp): Protects the cab dome light cir-
cuit.
Fuses F1--4, F2--3 and F2--4 are available for optional
equipment.
Fuse Testing
Make sure that ignition switch is OFF and key is re-
moved from switch. Remove fuse from fuse block and
check that fuse has continuity across the fuse terminals.
Electrical System
1
1. Cab headliner switches
1
2
3
4
Page 5 - - 30
2
Figure 30
2. Cab fuse blocks
F1 F2
15 A 15 A
15 A
15 A
30A
Figure 31
Groundsmaster 360