4-1.2 Static Table - ZyXEL Communications XGS3600 Series Manual

4-1.2 Static Table

The section describes to configure the Static IP Source Guard Table parameters of the switch.
You could use the Static IP Source Guard Table configure to manage the entries.
Web Interface
To configure a Static IP Source Guard Table Configuration in the web interface:
1. Click "Add new entry".
2. Specify the Port, VLAN ID, IP Address, and MAC address in the entry.
3. Click Apply.
Figure 4-1.2: The Static IP Source Guard Table
Parameter description:
Delete :

Check to delete the entry. It will be deleted during the next save.
Port :

The logical port for the settings.
VLAN ID :

The VLAN ID for the settings.
IP Address :

Allowed Source IP address.
IP Mask :

It can be used for calculating the allowed network with IP address.
Adding new entry :

Click "Adding new entry" to add a new entry to the Static IP Source Guard table. Specify
the Port, VLAN ID, IP address, and IP Mask for the new entry. Click "Apply".
Buttons:

Apply– Click to apply changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
XGS3600 Series User's Guide
259