Remote Management Limitations; Table 154 Menu 24.11 - Remote Management Control - ZyXEL Communications P-334WT User Manual

P-334WT User's Guide
The following table describes the fields in this screen.
Table 154 Menu 24.11 – Remote Management Control
FIELD
Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service
Port
Access
Secure Client IP The default 0.0.0.0 allows any client to use this service or protocol to access the
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.

36.1.1 Remote Management Limitations

Remote management over LAN or WAN will not work when:
1 A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or
Web service.
2 You have disabled that service in menu 24.11.
3 The IP address in the Secure Client IP field (menu 24.11) does not match the client IP
address. If it does not match, the Prestige will disconnect the session immediately.
4 There is an SMT console session running.
5 There is already another remote management session with an equal or higher priority
running. You may only have one remote management session running at one time.
6 There is a firewall rule that blocks it.
372
DESCRIPTION
Each of these read-only labels denotes a service or protocol.
This field shows the port number for the service or protocol. You may change the
port number if needed, but you must use the same port number to access the
Prestige.
Select the access interface (if any) by pressing [SPACE BAR], then [ENTER] to
choose from: LAN only, WAN only, ALL or Disable.
Prestige. Enter an IP address to restrict access to a client with a matching IP
address.
Chapter 36 Remote Management