Gui-Based Tftp Clients; Restore Configuration; Restore Using Ftp; Table 150 General Commands For Gui-Based Tftp Clients - ZyXEL Communications P-334WT User Manual

802.11g wireless broadband router with firewall
Hide thumbs Also See for P-334WT:
Table of Contents

Advertisement

where "i" specifies binary image transfer mode (use this mode when transferring binary files),
"host" is the Prestige IP address, "get" transfers the file source on the Prestige (rom-0, name of
the configuration file on the Prestige) to the file destination on the computer and renames it
config.rom.

34.2.8 GUI-based TFTP Clients

The following table describes some of the fields that you may see in GUI-based TFTP clients.

Table 150 General Commands for GUI-based TFTP Clients

COMMAND
Host
Send/Fetch
Local File
Remote File
Binary
Abort

34.3 Restore Configuration

This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your Prestige
since FTP is faster. Please note that you must wait for the system to automatically restart after
the file transfer is complete.
Note: WARNING! Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE YOUR Prestige.

34.3.1 Restore Using FTP

For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file
upload in this chapter
Chapter 34 Firmware and Configuration File Maintenance
DESCRIPTION
Enter the IP address of the Prestige. 192.168.1.1 is the Prestige's default IP address
when shipped.
Use "Send" to upload the file to the Prestige and "Fetch" to back up the file on your
computer.
Enter the path and name of the firmware file (*.bin extension) or configuration file
(*.rom extension) on your computer.
This is the filename on the Prestige. The filename for the firmware is "ras" and for the
configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
P-334WT User's Guide
359

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents