Remote Management Limitations; Remote Management And Nat; System Timeout; Www Screen - ZyXEL Communications NBG-418N v2 User Manual

13.1.1 Remote Management Limitations

Remote management over LAN or WAN will not work when:
You have disabled that service in one of the remote management screens.
1
The IP address in the Secured Client WAN IP Address field does not match the client IP address.
2
If it does not match, the NBG-418N v2 will disconnect the session immediately.
There is already another remote management session with an equal or higher priority running. You
3
may only have one remote management session running at one time.
There is a firewall rule that blocks it.
4

13.1.2 Remote Management and NAT

When NAT is enabled:
• Use the NBG-418N v2's WAN IP address when configuring from the WAN.
• Use the NBG-418N v2's LAN IP address when configuring from the LAN.

13.1.3 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds). The
NBG-418N v2 automatically logs you out if the management session remains idle for longer than
this timeout period. The management session does not time out when a statistics screen is polling.
You can change the timeout period in the System screen.

13.2 WWW Screen

To change your NBG-418N v2's World Wide Web settings, click Management > Remote MGMT to
display the WWW screen.
Figure 81 Management > Remote MGMT > WWW
Chapter 13 Remote Management
NBG-418N v2 User's Guide
116