Activating Otist; Figure 43 Otist; Table 35 Otist - ZyXEL Communications P-334WT User Manual

P-334WT User's Guide

Figure 43 OTIST

The following table describes the labels in this screen.

Table 35 OTIST

LABEL
Setup Key
Yes!
Start

4.5.1 Activating OTIST

After you click Start, a dialog box displays the security mode and the WEP key or pre-shared
key depending on which mode is configured. Click OK to proceed with the OTIST setup.
100
DESCRIPTION
Type an OTIST Setup Key of exactly eight ASCII characters in length.
The default OTIST setup key is "01234567".
Note: If you change the OTIST setup key here, you must also
make the same change on the wireless client(s).
If you want to configure your own WPA-PSK and have OTIST use that WPA-
PSK, you must:
• Configure a WPA-PSK in the Wireless General screen.
• Clear the Yes! checkbox in the OTIST screen and click Apply.
Note: If you already have a WPA-PSK configured in the
Wireless General screen, and you run OTIST with Yes!
selected, OTIST will not replace the WPA-PSK. Clear the
checkbox in the OTIST screen.
If you want OTIST to automatically generate a WPA-PSK, you must:
• Change your security to None in the Wireless General screen.
• Select the Yes! checkbox in the OTIST screen and click Apply.
• The wireless screen displays an auto generated WPA-PSK and is now in
WPA-PSK security mode.
The WPA-PSK security settings are assigned to the wireless client when you
start OTIST.
Click Start to encrypt the wireless security data using the setup key and have
the Prestige set the wireless station to use the same wireless settings as the
Prestige. You must also activate and start OTIST on the wireless station at the
same time.
The process takes three minutes to complete.
Chapter 4 Wireless LAN