Protocol Dependent Ethernet Setup; Tcp/Ip Ethernet Setup And Dhcp; Figure 152 Menu 3.2 Tcp/Ip And Dhcp Ethernet Setup; Table 115 Dhcp Ethernet Setup Fields - ZyXEL Communications P-334WT User Manual

P-334WT User's Guide

24.2 Protocol Dependent Ethernet Setup

Depending on the protocols for your applications, you need to configure the respective
Ethernet Setup, as outlined below.
• For TCP/IP Ethernet setup refer to the Internet Access Application chapter.
• For bridging Ethernet setup refer to the Bridging Setup chapter.

24.3 TCP/IP Ethernet Setup and DHCP

Use menu 3.2 to configure your Prestige for TCP/IP.
To edit menu 3.2, enter 3 from the main menu to display Menu 3 — LAN Setup. When menu
3 appears, press 2 and press [ENTER] to display Menu 3.2 — TCP/IP and DHCP Ethernet
Setup, as shown next

Figure 152 Menu 3.2 TCP/IP and DHCP Ethernet Setup

DHCP= Server
Client IP Pool:
Starting Address= 192.168.1.33
Size of Client IP Pool= 32
First DNS Server= From ISP
IP Address= N/A
Second DNS Server= From ISP
IP Address= N/A
Third DNS Server= DNS Relay
IP Address= N/A
DHCP Server Address= N/A
Follow the instructions in the next table on how to configure the DHCP fields.

Table 115 DHCP Ethernet Setup Fields

FIELD
DHCP
Client IP Pools
Starting Address
280
:
Menu 3.2 - TCP/IP and DHCP Ethernet Setup
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
This field enables/disables the DHCP server.
If set to Server, your Prestige will act as a DHCP server.
If set to None, the DHCP server will be disabled.
If set to Relay the Prestige acts as a surrogate DHCP server and relays requests
and responses between the remote server and the clients.
When set to Server, the following items need to be set:
This field specifies the first of the contiguous addresses in the IP address pool.
TCP/IP Setup:
IP Address= 192.168.1.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-1
Multicast= None
Edit IP Alias= No
Chapter 24 Menu 3 LAN Setup