ZyXEL Communications P-334WT User Manual page 299

Table 128 Menu 11.6 Traffic Redirect Setup
FIELD
Check WAN IP
Address
Fail Tolerance
Period (sec)
Timeout (sec)
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or
[ESC] to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen
Chapter 26 Remote Node Configuration
DESCRIPTION
Enter the IP address of a reliable nearby computer (for example, your ISP's DNS
server address) to test your Prestige's WAN accessibility.
The Prestige uses the default gateway IP address if you do not enter an IP address
here.
If you are using PPTP or PPPoE Encapsulation, enter "0.0.0.0" to configure the
Prestige to check the PVC (Permanent Virtual Circuit) or PPTP tunnel.
Enter the number of times your Prestige may attempt and fail to connect to the
Internet before traffic is forwarded to the backup gateway. Two to five is usually a
good number.
Enter the time interval (in seconds) between WAN connection checks. Five to 60 is
usually a good number.
Enter the number of seconds the Prestige waits for a ping response from the IP
Address in the Check WAN IP Address field before it times out. The number in this
field should be less than the number in the Period field. Three to 50 is usually a good
number.
The WAN connection is considered "down" after the Prestige times out the number of
times specified in the Fail Tolerance field.
P-334WT User's Guide
299