Bandwidth Management Monitor; Figure 120 Bandwidth Management: Monitor; Table 93 Bandwidth Management Rule Configuration: User-Defined Service - ZyXEL Communications P-334WT User Manual

The following table describes the labels in this screen.

Table 93 Bandwidth Management Rule Configuration: User-defined Service

LABEL
BW Budget
Destination
Address
Destination
Subnet Netmask
Destination Port
Source Address
Source Subnet
Netmask
Source Port
Protocol
OK
Cancel

15.10 Bandwidth Management Monitor

Click the Bandwidth MGMT link under Management and the Monitor tab to open the
bandwidth management Monitor screen. View the bandwidth usage of the WAN configured
bandwidth rules. This is also shown as bandwidth usage over the bandwidth budget for each
rule. The gray section of the bar represents the percentage of unused bandwidth and the orange
color represents the percentage of bandwidth in use.

Figure 120 Bandwidth Management: Monitor

Chapter 15 Bandwidth Management
DESCRIPTION
Select Maximum Bandwidth or Minimum Bandwidth and specify the maximum
or minimum bandwidth allowed for the rule in kilobits per second.
Enter the destination IP address in dotted decimal notation.
Enter the destination subnet mask. This field is N/A if you do not specify a
Destination Address. Refer to the appendices for more information on IP
subnetting.
Enter the port number of the destination. See
common services and port numbers.
Enter the source IP address in dotted decimal notation.
Enter the destination subnet mask. This field is N/A if you do not specify a Source
Address. Refer to the appendices for more information on IP subnetting.
Enter the port number of the source. See
services and port numbers.
Select the protocol (TCP or UDP) or select User defined and enter the protocol
(service type) number.
Click OK to save your customized settings.
Click Cancel to exit this screen without saving.
P-334WT User's Guide
Table 88 on page 222
Table 88 on page 222 for some common
for some
229