Figure 197 Menu 21.1.1.1 Tcp/Ip Filter Rule; Table 137 Menu 21.1.X.x Tcp/Ip Filter Rule - ZyXEL Communications P-334WT User Manual

P-334WT User's Guide
To configure TCP/IP rules, select TCP/IP Filter Rule from the Filter Type field and press
[ENTER] to open Menu 21.1.x.x - TCP/IP Filter Rule, as shown next

Figure 197 Menu 21.1.1.1 TCP/IP Filter Rule.

The following table describes how to configure your TCP/IP filter rule.

Table 137 Menu 21.1.x.x TCP/IP Filter Rule

FIELD
Active
IP Protocol
IP Source Route
Destination
IP Address
IP Mask
Port #
Port # Comp
326
Menu 21.1.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 0
Destination: IP Addr= 0.0.0.0
Source: IP Addr= 0.0.0.0
TCP Estab= N/A
More= No
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Press [SPACE BAR] and then [ENTER] to select Yes to activate
the filter rule or No to deactivate it.
Protocol refers to the upper layer protocol, e.g., TCP is 6, UDP is
17 and ICMP is 1. Type a value between 0 and 255. A value of 0
matches ANY protocol.
Press [SPACE BAR] and then [ENTER] to select Yes to apply
the rule to packets with an IP source route option. Otherwise the
packets must not have a source route option. The majority of IP
packets do not have source route.
Enter the destination IP Address of the packet you wish to filter.
This field is ignored if it is 0.0.0.0.
Enter the IP mask to apply to the Destination: IP Addr.
Enter the destination port of the packets that you wish to filter.
The range of this field is 0 to 65535. This field is ignored if it is 0.
Press [SPACE BAR] and then [ENTER] to select the comparison
to apply to the destination port in the packet against the value
given in Destination: Port #.
IP Source Route= No
IP Mask= 0.0.0.0
Port #= 137
Port # Comp= Equal
IP Mask= 0.0.0.0
Port #=
Port # Comp= None
Log= None
Chapter 30 Filter Configuration
OPTIONS
Yes
No
0-255
Yes
No
0.0.0.0
0.0.0.0
0-65535
None
Less
Greater
Equal
Not Equal