Ieee 802.1X And Static Wep Key Exchange; Table 32 Wireless: 802.1X And Dynamic Wep - ZyXEL Communications P-334WT User Manual

The following table describes the labels in this screen.

Table 32 Wireless: 802.1x and Dynamic WEP

LABEL
ReAuthentication
Timer (in seconds)
Idle Timeout
Dynamic WEP Key
Exchange
Authentication Server
IP Address
Port Number
Shared Secret
Accounting Server
Active
IP Address
Port Number
Shared Secret
Apply
Reset

4.4.12 IEEE 802.1x and Static WEP Key Exchange

In order to configure and enable IEEE 802.1x and static WEP key exchange; click the
Wireless LAN link under Network to display the Wireless General screen. Select 802.1x +
Static WEP from the Security Mode list.
Chapter 4 Wireless LAN
DESCRIPTION
Specify how often wireless stations have to resend usernames and passwords in
order to stay connected. Enter a time interval between 10 and 9999 seconds. The
default time interval is 1800 seconds (30 minutes).
Note: If wireless station authentication is done using a RADIUS
server, the reauthentication timer on the RADIUS server
has priority.
The Prestige automatically disconnects a wireless station from the wired network
after a period of inactivity. The wireless station needs to enter the username and
password again before access to the wired network is allowed. The default time
interval is 3600 seconds (or 1 hour).
Select 64-bit WEP or 128-bit WEP to enable data encryption. Up to 32 stations
can access the Prestige when you configure dynamic WEP key exchange.
Enter the IP address of the external authentication server in dotted decimal
notation.
Enter the port number of the external authentication server. The default port
number is 1812.
You need not change this value unless your network administrator instructs you
to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external authentication server and the Prestige.
The key must be the same on the external authentication server and your
Prestige. The key is not sent over the network.
Select Yes from the drop down list box to enable user accounting through an
external authentication server.
Enter the IP address of the external accounting server in dotted decimal notation.
Enter the port number of the external accounting server. The default port number
is 1813.
You need not change this value unless your network administrator instructs you
to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external accounting server and the Prestige.
The key must be the same on the external accounting server and your Prestige.
The key is not sent over the network.
Click Apply to save your changes back to the Prestige.
Click Reset to reload the previous configuration for this screen.
P-334WT User's Guide
95