Advanced Wan Screen; Figure 53 Advanced - ZyXEL Communications P-334WT User Manual

Table 44 PPTP Encapsulation
LABEL
Private (PPPoE and
PPTP only)
WAN MAC Address
Factory default
Clone the computer's
MAC address
Set WAN MAC
Address
Apply
Reset

5.5 Advanced WAN Screen

To change your Prestige's advanced WAN settings, click the WAN link under Network, and
the Advanced tab. The screen appears as shown.

Figure 53 Advanced

Chapter 5 WAN
DESCRIPTION
This parameter determines if the Prestige will include the route to this remote
node in its RIP broadcasts. If set to Yes, this route is kept private and not
included in RIP broadcast. If No, the route to this remote node will be
propagated to other hosts through RIP broadcasts.
The MAC address section allows users to configure the WAN port's MAC
address by either using the Prestige's MAC address, copying the MAC
address from a computer on your LAN or manually entering a MAC address.
Select Factory default to use the factory assigned default MAC Address.
Select Clone the computer's MAC address - IP Address and enter the IP
address of the computer on the LAN whose MAC you are cloning. Once it is
successfully configured, the address will be copied to the rom file (ZyNOS
configuration file). It will not change unless you change the setting or upload a
different ROM file.
Select this option and enter the MAC address you want to use.
Click Apply to save your changes back to the Prestige.
Click Reset to begin configuring this screen afresh.
P-334WT User's Guide
119