Ike Setup; Figure 242 Menu 27.1.1.1 Ike Setup; Table 158 Menu 27.1.1.1 Ike Setup - ZyXEL Communications P-334WT User Manual

38.3 IKE Setup

To edit this menu, the Key Management field in Menu 27.1.1 – IPSec Setup must be set to
IKE. Move the cursor to the Edit Key Management Setup field in Menu 27.1.1 – IPSec
Setup; press [SPACE BAR] to select Yes and then press [ENTER] to display Menu 27.1.1.1
– IKE Setup.

Figure 242 Menu 27.1.1.1 IKE Setup

The following table describes the fields in this menu.

Table 158 Menu 27.1.1.1 IKE Setup

FIELD
Phase 1
Negotiation
Mode
PSK
Chapter 38 VPN/IPSec Setup
Menu 27.1.1.1 - IKE Setup
Phase 1
Negotiation Mode= Main
Pre-Shared Key= ?
Encryption Algorithm= DES
Authentication Algorithm= MD5
SA Life Time (Seconds)= 28800
Key Group= DH1
Phase 2
Active Protocol= ESP
Encryption Algorithm= DES
Authentication Algorithm= SHA1
SA Life Time (Seconds)= 28800
Encapsulation= Tunnel
Perfect Forward Secrecy (PFS)= None
Press Space Bar to Toggle.
DESCRIPTION
Press [SPACE BAR] to choose from Main or Aggressive and then press [ENTER].
See earlier for a discussion of these modes. Multiple SAs connecting through a
secure gateway must have the same negotiation mode.
Prestige gateways authenticate an IKE VPN session by matching pre-shared keys.
Pre-shared keys are best for small networks with fewer than ten nodes. Enter your
pre-shared key here. Enter up to 31 characters. Any character may be used,
including spaces, but trailing spaces are truncated.
Both ends of the VPN tunnel must use the same pre-shared key. You will receive a
"PYLD_MALFORMED" (payload malformed) packet if the same pre-shared key is
not used on both ends.
Press ENTER to Confirm or ESC to Cancel:
P-334WT User's Guide
383