Remote Management Limitations; Remote Management And Nat; System Timeout; Www Screen - ZyXEL Communications NBG-417N User Manual

Chapter 16 Remote Management

16.3.1 Remote Management Limitations

Remote management over LAN or WAN will not work when:
You have disabled that service in one of the remote management screens.
1
The IP address in the Secured Client IP Address field does not match the client IP address. If it
2
does not match, the NBG-417N will disconnect the session immediately.
There is already another remote management session with an equal or higher priority running. You
3
may only have one remote management session running at one time.
There is a firewall rule that blocks it.
4

16.3.2 Remote Management and NAT

When NAT is enabled:
• Use the NBG-417N's WAN IP address when configuring from the WAN.
• Use the NBG-417N's LAN IP address when configuring from the LAN.

16.3.3 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds). The
NBG-417N automatically logs you out if the management session remains idle for longer than this
timeout period. The management session does not time out when a statistics screen is polling. You
can change the timeout period in the System screen

16.4 WWW Screen

To change your NBG-417N's World Wide Web settings, click Management > Remote MGMT to
display the WWW screen.
Figure 87 Management > Remote MGMT > WWW
The following table describes the labels in this screen
136
NBG-417N User's Guide