Routine Maintenance Activities; Cleaning Procedures - Xerox Phaser 8860 Service Manual

Routine Maintenance Activities

Procedure
1. Clean the Pick Rollers on every call.
2. Use the Control Panel to check maintenance item counters.
3. Compare the counter values to those listed in
4. Advise the customer of any routine maintenance items that are approaching or over the
service limit.
Table 1 Routine Maintenance Item Life Expectancy
Routine Maintenance Items
Extended-Capacity Maintenance Kit
Standard-Capacity Maintenance Kit
Waste Tray
DADF Pick Rollers and Separator Pad
Initial Issue
Phaser 8860/8860MFP Service Manual
Table 1.
30,000 cycles (0-20% coverage)
20,000 cycles (20-100%) coverage.
10,000 cycles
Empty every 7 Purges
50,000 scans

Cleaning Procedures

Purpose
The purpose is to provide cleaning procedures to be performed at every call.
Procedure
Do not use any solvents unless directed to do so in this manual.
General Cleaning
Use a dry lint free cloth or a lint free cloth moistened with water for all cleaning unless directed
otherwise in this manual. Wipe with a dry, lint free cloth if a moistened cloth is used.
1. Feed Components (Rolls and Pads)
Follow the General Cleaning procedure above.
2. Jam Sensors
Clean the sensors with a dry cotton swab.
3. Scanner
a. Using the optical Cleaning Cloth, clean the Document Glass.
b. Clean the Document Cover.
4. DADF
Check the paper path for debris or damage. Clean the rolls with a clean cloth and Film
Remover as required.
09/2007
Routine Maintenance Activities, Cleaning Proce-
1-5
CAUTION
Service Call Procedures