23,133.4X Ram Faults; Error Messages And Codes; 26,0Xx.6X Printing Faults - Xerox Phaser 8860 Service Manual

23,133.4x RAM Faults

An RAM DIMM error has occurred. The following troubleshooting procedure applies to these
errors:
NVRAM Faults
23,133.4x The system detected an NVRAM fault during operation.
Initial Actions
• Reseat RAM devices and retest.
• If the problem persists, follow the procedure below.
Primary Causes
The troubleshooting table lists parts and wiring referenced in the troubleshooting procedure.
Table 1 23,0XX.6x Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
SDRAM, PL 5.0 or PL 5.1
Electronics Module, PL 5.0 Electronics Module -
or PL 5.1 (8860)
Troubleshooting Procedure
Table 2 X-Axis Program Faults Troubleshooting Procedure
Step Questions or Actions
1 Reseat the SDRAM devices in the Elec-
tronics Module.
Does the problem persist?
2 Replace SDRAM.
Does the problem persist?
Initial Issue
Phaser 8860/8860MFP Service Manual
Figure 8
Yes No
Go to Step 2. Complete.
Replace the Elec- Complete.
tronics Module (REP
5.0.5 or PL 5.1
(8860)).

26,0XX.6x Printing Faults

A printing process error has occurred. The following troubleshooting procedure applies to
these errors:
Printing Faults
26,0xx.6x A printing process fault occurred during operation.
26,962.64 A fall out code fault.
Initial Actions
• Reset NVRAM and retest.
• If the problem persists, follow the procedure below.
Troubleshooting Procedure
Check the fault history and troubleshoot the error listed immediately prior to these codes. Oth-
erwise, reboot the system to clear these error conditions.
09/2007
2-35

Error Messages and Codes

23,133.4x, 26,0XX.6x