Figure 2 Lowering the Printhead Wiper Blade
7.
Replace the left side Drive Gear and KL-Clip.
Repairs and Adjustments
ADJ 2.5.1, ADJ 4.7.1
ADJ 4.7.1 Process Drive Alignment
Purpose
To place the Process Drive in the home position.
Place the Printhead, Head Tilt Gear, Printhead Wiper Blade, and Process Drive in their home
positions before restoring system power. Improper alignment could result in damage or errors.
Adjustment
Examine the Process Drive alignment points to verify proper gear alignment:
•
The holes in the Process Drive and gears must align as indicated in
Figure 1 Process Drive Gear Alignment
•
The hole in the Camshaft gear must align with the arrow on the chassis.
•
The hole in the Transfix Camshaft Gear must align with the hole in the chassis.
09/2007
4-80
CAUTION
Figure
1.
Phaser 8860/8860MFP Service Manual
Initial Issue