Rep 4.0.5 X-Axis Motor; Repairs And Adjustments - Xerox Phaser 8860 Service Manual

Replacement
Perform the Head Tilt Gear (ADJ 4.13.1), and Process Drive Alignment
ments before restoring system power.
Initial Issue
Phaser 8860/8860MFP Service Manual

REP 4.0.5 X-Axis Motor

(ADJ 4.7.1) adjust-
Parts List on
Removal
1. Remove the Right Side Cover
2. Disconnect the X-Axis Motor (P/J150) from the Right Side Harness.
3. Remove 4 (plastic, T-20) screws that secure the motor to the frame.
Replacement
Engage the fork extending from the motor shaft to the Side Rail as shown in
the mounting plate behind the ground strap and replace the cable retainer on the lower right
screw. Perform the Head Tilt Gear
adjustments before restoring system power.
09/2007
4-51
PL 4.0
(REP 1.0.21 or REP 1.1.10
Figure 1 Removing the X-Axis Motor
(ADJ 4.13.1), and Process Drive Alignment
for the 8860).
Figure 1. Also, slip
(ADJ 4.7.1)

Repairs and Adjustments

REP 4.0.4, REP 4.0.5