Xerox Phaser 8860 Service Manual page 143

Figure 5 Removing the Printhead Restraint Screws
NOTE: Adjust the Printhead along its X-Axis as needed using a small screwdriver
inserted in the slot on the X-Axis Motor to allow removal of the Printhead Restraints.
Figure 6 Removing the Printhead Restraints
13. Remove the Roll Block on the left end of the Printhead Shaft.
Initial Issue
Phaser 8860/8860MFP Service Manual
Figure 7 Removing the Roll Block
NOTE: The check mark on the label indicates the proper orientation of the Roll Block.
14. Disconnect the Printhead Heater Harness
09/2007
4-19
P/J3 and free the harness from the restraint.
Repairs and Adjustments
REP 2.0.2