Rep 5.0.24 Back Frame (8860Mfp) - Xerox Phaser 8860 Service Manual

Replacement
Verify that no wiring is routed behind the Drum Heater Relay Board before installing the
screws.
When replacing the Drum Heater Relay Board screws, torque to no more than 12 in.-lbs. Over-
tightening these fasteners can result in irreversible damage to the chassis.
Initial Issue
Phaser 8860/8860MFP Service Manual
WARNING
CAUTION

REP 5.0.24 Back Frame (8860MFP)

Parts List on PL 5.0
Removal
1. Remove the Scanner Assembly with attached DADF
2. Remove the Output Tray (REP
3. Remove the Left Side Cover
4. Remove the Right Side Cover
5. Remove the Rear Cover (REP
6. Remove the Ink Loader (REP
7. Remove the Scanner Power Supply Fan
8. Remove the Exit Module Board
9. Remove the Scanner Power Supply
10. Remove the Electronics Module
11. Remove the Printer Stabilizer
12. Remove 7 (metal, T-20) screws that secure the Back Frame to the chassis.
Figure 1 Removing the Back Frame
09/2007
4-69
(REP 1.0.11).
1.0.6).
(REP 1.0.7).
(REP 1.0.21).
1.0.20).
2.0.1).
(REP 4.0.3).
(REP 5.0.1).
(REP 5.0.2) and mylar insulator.
(REP 5.0.5).
(REP 3.0.14).
Repairs and Adjustments
REP 5.0.19, REP 5.0.24