2,006.Xx I/O Board Program Faults; 2,0Xx.6X Configuration Card Faults - Xerox Phaser 8860 Service Manual

2,006.xx I/O Board Program Faults

The following troubleshooting procedure applies to these errors:
I/O Board Program Faults
2,001.69 The Electronics Module Failed to initialize.
2,002.61 Firmware program fault
2,003.62 Firmware program fault
2,004.63 Failure to start the Print Engine in Suspend Mode.
2,005.64 ROM read error
2,006.65 ROM read error
2,007.66 idiags entry point access error
Initial Actions
• Reset NVRAM and retest.
• Check that all connections to the Electronics Module and I/O Board are secure by reseat-
ing each connection.
• If the problem persists, follow the procedure below.
Primary Causes
The troubleshooting table lists parts and wiring referenced in the troubleshooting procedure.
Table 1 2,006.xx Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
I/O Board, PL 5.0.13
NVRAM, PL 5.0.9
Troubleshooting Procedure
Table 2 I/O Board Error Troubleshooting Procedure
Step Questions or Actions
1 Reseat all I/O Board connections.
Does the problem persist?
2 Reseat all Electronics Module connec-
tions.
Does the problem persist?
3 Check ground integrity.
Are the system grounds connected?
Error Messages and Codes
2,006.xx, 2,0XX.6x
Yes No
Go to Step 2. Complete.
Go to Step 3. Complete.
Replace the NVRAM Reconnect the sys-
device (REP 5.0.9). tem grounds.

2,0XX.6x Configuration Card Faults

The following troubleshooting procedure applies to these errors:
I/O Board Program Faults
2,008.67 The Configuration Card is Missing
2,009.68 The Configuration Card is Bad
2,010.69 The Configuration Card is Blank
2,011.61 The Configuration Card is for the wrong product
2,012.62 The Configuration Card is an invalid model
Initial Actions
• Turn Off the system.
• Check that the Configuration Card is correct for the system.
• Turn the system On.
• If the problem persists, follow the procedure below.
Primary Causes
The troubleshooting table lists parts and wiring referenced in the troubleshooting procedure.
Table 1 2,006.xx Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
Electronics Module, PL 5.0
Configuration Card, PL 5.0
Troubleshooting Procedure
Table 2 Configuration Card Faults Troubleshooting Procedure
Step Questions or Actions
1 Replace the Configuration Card, restart
the system, and retest.
Does the problem persist?
2 Check ground integrity.
Are the system grounds connected?
3 Replace the Electronics Module.
Does the problem persist?
09/2007
2-10
Yes No
Go to Step 2. Complete.
Go to Step 3. Reconnect the sys-
tem grounds.
Complete.
Initial Issue
Phaser 8860/8860MFP Service Manual