Adjustment; Noise Level Adjustment (Noise Level) - JRC JMA-5312-6 Instruction Manual

Hide thumbs Also See for JMA-5312-6:

Table of Contents

ADJUSTMENT

This section describes the electrical adjustment procedures to be performed by service engineers during

system installation.

Any adjustments must be made by specialized service

Incorrect settings may result in unstable operation.

Do not make any adjustments during navigation. Failure

to comply may result in adverse effects on the radar

function which may lead to accidents or equipment failure.

[I] Noise Level Adjustment for Signal Processing

1. Open the Serviceman Menu.

2. Open the Echo Noise Level menu by performing the following menu

3. Increase/decrease the noise level adjustment value.

The noise level is factory-set.

After system installation, a great change in the noise level adjustment value should be

avoided; it should be fine adjusted within ±5.

9. SP/TT Initial Setup

→ 1. Signal Processing

→ 1. Echo Noise Level