Set User Keys [User Key 1 / 2] - JRC JMA-5312-6 Instruction Manual

3.8.7

Set User Keys [USER KEY 1 / 2]

Users can freely make settings with [USER KEY1] key and [USER KEY2] key.
By using the keys, users can open a frequently used menu by only single operation, or assign special
functions, to the user key switches.
[I] Initial Setting (User Key Setting)
Set functions that can be performed with the user key switches.
Procedures 1 Press the [RADAR MENU] key twice.
2 Open the User Key Setting menu by performing the following menu
operation.
This system provides two user keys: [USER KEY1] and [USER KEY2]. Different functions can be
allocated to each key.
Functions that can be allocated to each key are as follows:
Menu
Zoom
TM Reset
[II] Using User Keys (Directly displaying a specified menu)
Preset the menu that is to be displayed with the user key switch.
Procedures 1 Make the initial setting for the user key to
Make settings in accordance with Section [I] Initial Setting (User Key Setting).
2 Perform the general menu open procedure to open the menu that is
to be directly displayed with User Key.
3 While the menu is open, Press the [USER KEY1] key or [USER KEY2]
key for 2 seconds.
The menu currently being displayed is saved for the pressed user key.
Directly displaying the menus assigned to the User Keys
Procedures 1 Press the [USER KEY1] key or the [USER KEY2] key.
The menu set for the pressed user key will open.
Subsequently, general menu operation can be performed.
5. Sub Menu
→ 4. User Key Setting
: A specific menu is directly displayed.
: The zoom display function is switched between on and off.
: Reset to initial own ship position in true motion display mode.
3-90
3.8 Applied Operations
Menu .
3