Dgps Receiver Setting (Dgps Setting) - JRC JMA-5312-6 Instruction Manual

[Ⅷ] Master reset
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
2. Press the [9] key to send the setting value while the master reset is

3.4.21 DGPS Receiver Setting (DGPS Setting)

Set to a JRC's DGPS receiver.
This setting is enabled when a JRC's DGPS is connected to the GPS connector of processor unit.
[I] Beacon frequency mode setting (Mode)
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
2. Press the [1] key to select the beacon frequency mode.
3. Press the [5] key to send the setting value to DGPS receiver.
[Ⅱ] Beacon frequency setting(Frequency)
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
2. Enter the beacon frequency.
3. Press the [5] key to send the setting value to DGPS receiver.
menu procedure to set the Master Reset On.
4. NAV Equipment Setting
→ 4. GPS Setting
on.
menu open procedure to open the DGPS Setting menu.
4. NAV equipment Setting
→ 4. GPS Setting
AUTO : The beacon frequency mod is selected automatically
Manual : The beacon frequency mod is selected manually
This setting is enabled when beacon frequency mode is set to manual.
menu open procedure to open the Frequency menu.
4. NAV equipment Setting
→ 4. GPS Setting
→ 1. GPS Process Setting
→ 8. Master Reset
→ 2. DGPS Setting
→ 2. DGPS Setting
→ 2. Frequency
3-43