JRC JMA-5312-6 Instruction Manual page 142

Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
2. Select the satellite or the beacon whose differential information is
3. Press the [6] key to send the setting value to SBAS receiver.
[Ⅱ] Ranging satellite setting (Ranging)
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
2. Press [2] key to select the SBAS satellite to be used or not to be
3. Press the [6] key to send the setting value to SBAS receiver.
[Ⅲ] Prohibitive satellite setting (NG SBAS)
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
2. Press [3] key to select the information from prohibitive SBAS satellite
3. Press the [6] key to send the setting value to SBAS receiver.
menu open procedure to open the Mode menu.
4. NAV equipment Setting
→ 4. GPS Setting
used.
Beacon : SBAS receiver use the information from beacon
SBAS : SBAS receiver use the information from SBAS satellite
AUTO : SBAS receiver selects automatically
Set the SBAS satellite to be used or not to be used.
menu open procedure to open the SBAS Setting menu.
4. NAV equipment Setting
→ 4. GPS Setting
used.
On : SBAS satellite is used
Off : SBAS satellite is not used
Set the information from prohibitive SBAS satellite to be used or not to be used.
menu open procedure to open the SBAS Setting menu.
4. NAV equipment Setting
→ 4. GPS Setting
to be used or not to be used.
On : The information from prohibitive SBAS satellite is used
Off : The information from prohibitive SBAS satellite is not used
→ 3. SBAS Setting
→ 1. Mode
→ 3. SBAS Setting
→ 3. SBAS Setting
3-45