Use Route Function; Display Destination Mark (Nmea Waypoint Display) - JRC JMA-5312-6 Instruction Manual

3.7

USE ROUTE FUNCTION

In this radar system, a destination mark set by navigation equipment can be displayed and a simple
route can be created, displayed, loaded and saved. (To use this function, navigation equipment must
be connected to this system)
A plotter unit (option) is required to create, display, load and save the simple route.
If radar video is poor visibility caused by route function, click the
function. Otherwise, press the [DATA OFF] key to map displays temporarily off.
3.7.1

Display Destination Mark (NMEA Waypoint Display)

A destination mark sent from the external navigation equipment can be displayed.
If route type set
Procedures 1
2
ECDIS , refer to "3.7.2 Receive Route Data Setting".
Open the Plot menu by performing the following menu operation.
Plot
Press the [7] key.
The NMEA Waypoint Display is turned on or off.
Off : Destination is not displayed.
On : Destination is displayed.
When On is selected, the ○WP mark appears of the display.
The destination mark is displayed only when Waypoint data is received from outside
by the NMEA sentence (RMB,BWC,BWR).
3-79
Map button to turn off the Map