Chart Plotting Bearing Mode (Map Draw Azi Mode) - JRC JMA-5312-6 Instruction Manual

3 Press the [0] key, and then [ENT] key.
The correction value for the longitudinal direction will be set to 0.
[4] Map Center Position
This method corrects a chart position by entering the values of latitude and longitude at own ship's
position in manual mode.
If latitude and longitude data sent by the navigation equipment has been entered, the data has priority
over the manually entered values.
Procedures 1 Press the [4] while the Map Display Setting Menu is open.
The latitude / longitude input screen for the Map Center Position menu will appear.
2 Enter a latitude / longitude value.
For how to enter a value on the latitude / longitude input screen, see Section 3.3.4.
The latitude / longitude correction value is determined.
Cancellation 1 Press the [4] key while the Map Display Setting menu is open.
The latitude / longitude input screen for the Map Center Position menu will appear.
2 Press the [0] key, and then press the [ENT] key.
The latitude direction correction value will set at 0.
3 Press the [0] key, and then press the [ENT] key.
The longitude direction correction value will be set at 0.

3.12.8 Chart plotting bearing mode (Map Draw AZI Mode)

Procedures 1 Press the [Map] key for 2 seconds.
The Map Setting menu will appear.
2 Press the [7] key.
The Map Draw AZI Mode are switched.
N-Up : The chart is displayed in the North-up mode.
C-Up : The chart is displayed in the Course-up mode.
3-122
3.12 Display Simple Chart
3