Setting Of Ccrp/Antenna/Gps Antenna Position (Ccrp Setting) - JRC JMA-5312-6 Instruction Manual

7.1.9 Setting of CCRP/Antenna/GPS Antenna Position (CCRP
Setting)
Set the own ship's CCRP location, radar antenna installation location, and GPS installation location.
CCRP
Radar antenna : Up to eight radar antennas can be input. (Automatically selected in response to
GPS
Procedures 1. Measure the CCRP location, radar antenna location, and GPS antenna
2
3. Open the Serviceman Menu.
4. Open the CCRP Setting menu by performing the following menu
5. Specify the ship length for Length at the upper right of the CCRP
6. Move the cursor onto the CCRP1 X, Y value, and press the ENT key to
7. To input the second CCRP, press the
8. Repeat the above steps to input the GPS location(s) and radar
9. If multiple CCRP locations and GPS locations are input, select the
10. Press [0] key to close the CCRP Setting menu.
: Up to four locations can be input. (One location selected when used)
ISW operation)
: Up to four locations can be input. (One location selected when used)
location in advance.
Press the [STBY] key.
The transmission standby state is activated.
operation.
2. Installation Menu
→ 4. CCRP Setting
Setting Menu, and the ship width for Beam.
input the CCRP1 location.
When X > 0, the CCRP is on the starboard side of the ship. When X < 0, it is on the
port side.
CCRP2 X,Y value, and input the value in the same manner for step 5.
Similarly, input the third and subsequent CCRPs.
antenna location(s).
CCRP location and GPS location to be used by pressing the buttons at
the upper left of the menu.
CCRP2
7-9
button to display the