JRC JMA-5312-6 Instruction Manual page 362

[IV] Receive Sentence Setting (RX Sentence)
Select Use/no Use for each sentences.
The system is factory-set for using all sentences.
To receive only specified sentences, select No Use for sentences which are not necessary.
Procedures 1. Open the Serviceman Menu.
2. Open the RX Sentence menu by performing the following menu
3. Select the sentences used by the sensors to be set.
operation.
2. Installation Menu
→ 9. Next
→ 5. LAN Port Setting
Selection value: Use or Not Use can be selected for each sentence.
1. GPS(LL/COG/SOG)
2. GPS(WPT/Time)
3. Depth
4. Wind
5. Current
Data Set Number
Layer A
Layer B
Layer C
6. Autopilot
→ 3. RX Sentence
: GGA/RMC/RMA/GNS/GLL/VTG
: GGA/RMC/RMB/BWC/BWR/ZDA
: DPT/DBK/DBT/DBS
: MWV/MWD
:
: 0-9. Set the number of the sentence to be used by
Data Set Number. (Initial value All)
: 0-999. Set the number of the sentence to be used
with layer A by Layer Number. (default value : 3)
: 0-999. Set the number of the sentence to be used
with layer B by Layer Number. (default value : 4)
: 0-999. Set the number of the sentence to be used
with layer C by Layer Number. (default value : 5)
: APB (default value : Not Use)
7-29