JRC JMA-5312-6 Instruction Manual page 242

[II] Operating Variable Range Marker (VRM)
Procedures 1
2
3
[III] Operating EBL and VRM Concurrently (EBL and VRM)
Procedures 1
2
3
[IV] Operating Parallel Index Lines (PI)
To change the direction of parallel index lines
Procedures 1
2
3
Put the cursor on VRM1 or VRM2, and press the [ENT] key.
When the cursor is moved to it, VRM1 or VRM2 is shown at the upper right
of the cursor. The VRM becomes operable when the [ENT] key is pressed.
Move the cursor to the range to be set.
The VRM will move as the cursor moves.
Press the [ENT] key.
The VRM will be fixed.
Put the cursor on the intersection marker ( ○
the
[ENT] key.
When the cursor is moved to it,
upper right of the cursor. The EBL and VRM become operable when the [ENT] key
is pressed.
Move the cursor to the bearing / range to be set.
The EBL and VRM will move as the cursor moves.
Press the [ENT] key.
The EBL and VRM will be fixed.
Put the cursor on near the center of line, and press the [ENT] key.
When the cursor is moved there, it will turn into "
the upper right of the cursor. The parallel index lines become operable when the
[ENT] key is pressed.
Move the cursor to the direction to be set.
The parallel index lines will change the direction as the cursor moves.
Press the [ENT] key.
The parallel index lines will be fixed.
EBL1 VRM1 or EBL2 VRM2 is shown at the
4-15
press
or ● ), and
" and PI will be displayed at