JRC JMA-5312-6 Instruction Manual page 231

[I] Operating EBL (EBL)
To operate EBL
Procedures 1 Press the [EBL1] or [EBL2] key.
The EBL adjustment (upper right of the display ⑤/⑦ on page 2-19) will be
highlighted, and the selected EBL becomes operable.
2 Turn the [EBL] dial.
To turn the [EBL] dial to the right, turn the EBL control clockwise, to turn the [EBL]
dial to the left, turn the EBL control counterclockwise.
Cancellation 1 Press the [EBL1] or [EBL2] key again.
The selected EBL display will disappear.
[II] Moving the Starting Point of EBL
The system provides three types of EBL starting points. Select one of them in
accordance with purpose.
C
D
To move the starting point of EBL
Procedures 1 Make EBL1 or EBL2 operable.
2 Press the [EBL] dial to set
point mode switching (upper right of the display ⑪/⑫ on page 2-19).
The selected EBL starting point mode is switched as shown below each time the dial is
pressed.
3 Put the cursor on the EBL starting point is to be moved, and
the
The selected EBL starting point will be determined.
:The EBL starting point is defined as the own ship's position.
:The EBL starting point is moved and fixed on the radar display.
:The EBL starting point is moved and fixed at the latitude and longitude.
(The navigator needs to be connected.)
⇒ C ⇒ D ⇒
[ENT] key.
4-4
4.1 Use of Navigation Tools
C or D for the EBL1 / EBL2
4
starting
press